The FASS Titanium
series designed for the 1999-2004 Ford Powerstroke 6.0L/7.3L is available at Orange
County Diesel in Huntington Beach, California. If you have any questions about
any other FASS product, or if you need expert assistance installing your FASS
Platinum, feel free to call and speak to a FASS service professional at
714-848-2170.
This is Part 1
of a model-specific four-part series about how to install a FASS Platinum fuel
system.
Step 1: Install electrical harness.
The electrical harness is installed first in order for power
to be applied to the pump for lubrication purposes.
The red wire
of the WH-1001 wire harness will travel through the rubber grommet in the
firewall, or into the fuse panel in the engine compartment.
Use a test
probe to locate the hot side of the circuit in the fuse block. Connect the fuse
tap to the hot side of the fuse.
Using the
fuse tap and flag terminal, connect the red lead to a terminal on the circuit
board that is “hot” when the key is on.
Green wire
must be connected to a clean ground (preferably to the negative battery
terminal) without being exposed to any corrosion, preferably the negative
battery terminal. Secure fuse block in a location protected from outside
elements. Route wire harness along frame rail to the mounting location of pump.
No comments:
Post a Comment